Filter
Top Products
106
Section 7. Other Convenient Functions
1.
Hold down [EFFECTS] and press
[UTILITY].
fig.06-020
When the built-in tuner of the MICRO BR is
used, the reference pitch is shown in the
upper of the display, and the note name in
the right. The lower part will display a
tuning guide to indicate the difference
between the input sound and the displayed
note.
* You cannot switch from the Tuner screen to other
screens (except the Play screen).
2.
Setting the reference pitch.
You can set the reference pitch of the tuner
to any value between 435 and 445 Hz.
* This was set to 440 Hz when the unit was shipped from
the factory.
3.
Play a note using the string you are
tuning.
The screen will indicate the note name that is
closest to the pitch of the string you played.
* Cleanly play a single note only on the string you wish to
tune.
4.
Continue tuning until the pitch name of
the string you are tuning appears in the
display.
Normal tuning
5.
While viewing the tuning guide, adjust the
tuning so that is positioned midway
between the two sides.
If the pitch of the string is within +/-50 cents
of the correct pitch, the tuning guide will
indicate the discrepancy between the actual
and the correct pitches.
Your instrument is tuned above the
displayed note
fig.06-020
Your instrument is tuned the displayed
note
fig.06-020
Your instrument is tuned below the
displayed note
fig.06-020
6.
Repeat steps 3–5 to tune each of the
strings.
7.
When you finished tuning, press [EXIT].
Tuning
String
7th 6th 5th 4th 3rd 2nd 1st
Guitar
B E A D G B E
Bass B E A D G
If you do not want to output the tuning
sounds, either turn down the VOLUME
dial.