Filter
Top Products
38
Section 1.
Recording and playing back
Make sure that the display does not indicate
, (p. 42) or (p. 90).
On the MICRO BR, each of your compositions is
managed as a “song.” You’ll need to create a
song before you begin recording a new
composition.
1.
Press [UTILITY].
2.
Press [TR1] (SNG).
The SONG EDIT screen will appear.
fig.Disp-SONG-EDIT.eps
3.
Press [TR2] (NEW).
The display will indicate “Type:”
4.
Use VALUE [-][+] to select the data type
for the song you want to create.
fig.Disp-SongDataTyp.eps
5.
Press [TR4] (EXE).
A new song will be created, and you will
return to the Play screen.
About the data types
You must select the “data type” when you create
a new song on the MICRO BR. Choose one of the
following data types.
Recording time
The following table shows the recording time
available on one card of the listed capacities.
(These times are calculated as if you’re recording
just a single track.)
* Regardless of the data type, the sample rate is 44.1 kHz.
You can’t change the sample rate.
* You can’t change the data type of a song after it’s been
created.
* The recording times shown above are approximate. They
will decrease slightly depending on the number of songs
you’ve created.
* The recording times shown in the above table are for
when you use only one track. For example if you record
using all four tracks, each track can be one quarter of the
time length shown above.
Recording
Creating a new song