Filter
Top Products
Fine Tuning Your System
92
En
7 Use the buttons to select the
source you want. Press the ENTER
button.
When you assign an i.LINK-equipped video component,
select the input source to which you have connected the
video signal from the component. TUNER, PHONO and
USB inputs cannot be assigned.
If you want to change the ports for additional i.LINK
components
Start again from step 6.
• i.LINK is displayed after unassigned device names
such as DV-47Ai [i.LINK].
• When connected devices are not i.LINK-Audio compat-
ible source components, [----] is displayed after the
input device name such as DV-47Ai [----]. Non-compati-
ble devices cannot be assigned to inputs.
• When the cables for an assigned input device become
loose or the power is cut to the device, a * appears
before the device name (i.e. *DV-47Ai [CD]).
• If you assign an i.LINK input to a certain function (for
example DVD/LD) then any digital inputs previously
assigned to that function will automatically be set to
i.LINK (not assigned). This is because one function
cannot be assigned to two different places.
8 When you’re finished use the
buttons to select EXIT and press
ENTER.
You will leave the i.LINK INPUT mode.
9 Use the buttons to select EXIT
and press ENTER, again. Then, use the
buttons to select EXIT and press
ENTER.
Memo:
When a number of i.LINK-equipped components are
connected to your receiver, the i.LINK-equipped
component you are looking for might be listed on
additional display screens. When the top or bottom input
is selected, pressing button or will display any
previous or next display screen. When you press ENTER
the cursor moves to EXIT.
7
VSX-AX5i.book Page 92 Friday, May 23, 2003 6:33 PM