Filter
Top Products
Before You Start
7
En
PREPARATION
Checking the Supplied Accessories
Please check that you have received all of the following supplied accessories.
Memo:
Multi-voltage model has two power cords. These accessories will be different depending on the country of purchase.
Please use the correct cord for your country.
Preparing the Remote Control
Loading the batteries
Load the batteries into the remote control as shown below. Please use alkaline batteries. When you notice a
decrease in the operating range, replace all batteries with new ones.
Remote Control Battery Indicator
When the batteries get too weak to operate the remote control properly an
indicator warning screen will appear on the remote. Change the batteries as
shown above. This must be done within five minutes or all your remote control
settings will be cleared.
AM Loop Antenna FM Wire Antenna
“AA” IEC LR6
batteries x 4
Operating
Instructions
Remote Control Unit
Microphone for Auto
Microphone Stand for Auto
Surround Sound Setup
Surround Sound Setup
AC Power Cord
x 1 (European model)
x 2 (multi-voltage model)
12
3
“AA” IEC LR6
batteries x 4
CAUTION!
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions.
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries properly according to the marks in the battery case.
• Batteries with the same shape may have different voltages. Do not use different batteries together.
• When disposing of used batteries, please comply with governmental regulations or environmental public institution’s
rules that apply in your country or area.
Before You Start
Shows when the
batteries are getting weak
VSX-AX5i.book Page 7 Friday, May 23, 2003 6:33 PM