Filter
Top Products
Remote Control of Other Components
73
En
BASIC
Setting up the Direct Function
The direct function is designed in case you have an external video source connected to your TV (a video source that
is not going through the VSX-AX5i). For this explanation we'll call this the external video deck. You'd like to control
external video deck with this unit's remote control so you've assigned it a function button (for example purposes, the
VCR 2 button). Yet, if you put the receiver in VCR 2 mode you'll get no picture on your TV because the external video
deck signal is not going through the VSX-AX5i. To get around this problem you set the direct function for VCR 2 to
OFF. Now when you press VCR 2 function button you can control the external video deck with the remote but the
receiver does not go into VCR 2 mode.
1 Press the REMOTE SETUP button for
three seconds.
The REMOTE SETUP menu appears on the remote
display.
2Use the buttons to select
DIRCTFNC and press ENTER.
SELECT FUNCTION will flash in the remote control
display.
3 Press the MULTI CONTROL button of
the component whose direct function
you want to turn on or off.
DIRECTFUNC appears on the remote control display.
The TUNER button cannot be assigned.
4Use the buttons to select ON,
OFF, or EXIT and press ENTER.
ON: The direct function is on.
OFF: The direct function is off.
EXIT: Leaves the direct function settings and
returns you to the REMOTE SETUP menu.
After you press ENTER, if you chose one of the first
two settings, COMPLETE will appear in the display.
5 Repeat steps 2-4 to set the direct
function for as many components as
you want.
6 Press the REMOTE SETUP button to
return to the previous mode.
Memo:
• To exit from the REMOTE SETUP mode at
any time, press REMOTE SETUP.
• The default setting for all direct functions
is ON.
VSX-AX5i.book Page 73 Friday, May 23, 2003 6:33 PM