Filter
Top Products
Using Other Functions
83
En
EXPERT
Editing Remote Control Display Names
Use this capability to rename the display on the remote control for different MULTI CONTROL buttons (DVD/LD,
etc.). For example, you could change TV to DVD2. In this way you can personalize your system. This is similar to the
feature on page 93 but that feature changes the display on the receiver.
1 Press the REMOTE SETUP for more
than three seconds.
The REMOTE SETUP menu appears on the remote
display.
2Use the buttons to select
FUNCNAME and press ENTER.
SELECT FUNCTION will flash in the display.
3 Press the MULTI CONTROL button for
the component you want to rename.
For example, TV
4Use the buttons to select the
letters and/or numbers you want to
enter and use the buttons to
move the cursor to the next position.
Here are the possible letters/numbers.
You can input up to eight letter/numbers.
5 When you're finished press ENTER,
END will flash, press ENTER again.
The COMPLETE appears in the display.
6 Go back to step 2 to input as many
function names as you want.
7 Select EXIT and press ENTER.
You will exit the REMOTE SETUP menu and return to
normal operation.
Memo:
• To exit from the REMOTE SETUP mode at
anytime press the REMOTE SETUP button.
• The display will disappear after one minute or
so if no new commands are entered. Press
any button to wake up the remote and
continue the process.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!#%&'()*+–./:;<=>?
@[\]\^_`{|}~ •(space)
VSX-AX5i.book Page 83 Friday, May 23, 2003 6:33 PM