Easy Setup Guide Part 2
14
En
8 Select AUTO SETTING with the
buttons and press ENTER.
9 Some auto setup instructions will be
listed, make sure to follow them.
Make sure you have: hooked up the microphone and
moved obstacles to the speakers out of the way. If
you have a subwoofer make sure it is turned on and
has the volume turned up.
WARNING: The test tones are very loud!! Make sure
there are no infants or small children in the room
and that no one who will be scared, upset or injured
by loud noise is present. You yourself may want to
wear earplugs. It is possible to lower the volume of
test tones, but this could result in incorrect speaker
settings.
10 If you have followed all setup
instructions and warnings above
make sure that the arrow is pointed
to START and press ENTER. Be
prepared for loud test tones.
Try to be as quiet as possible after hitting ENTER. The
test tones may take up to 30 seconds.
The volume automatically increases to 0 dB, then the
system will output some test tones and establish
ambient noise levels, the microphone status, and
what speakers you hooked up.
11 Check the speaker settings on the
OSD.
If they match your speaker configuration make sure
OK is selected and press ENTER. The test tones will
be output loudly again. The test tones may take up to
5 minutes this time.
After they have finished, you see the SPEAKER SYS-
TEMS CHECK screen. If you want to view the settings
select NEXT and press ENTER repeatedly. If not, sim-
ply go to step 13.
If they do not match the speaker configuration you
hooked up and you want to try again select RETRY
with buttons and press ENTER. Follow the
instructions above from step 10.
If you get an error message instructing you to do
something, follow the instructions and RETRY with
buttons and press ENTER.
If the speaker settings do not match the speaker con-
figuration you connected and you want to input the
settings manually select ERR FIX SP with the
buttons, press ENTER. Go to step 12.
If you see an ERR message in the right side column,
there may be a problem with the speaker connection.
If selecting RETRY doesn't fix the problem, turn off
the power and check the speaker connections.
Speaker Distance
8
10
11
VSX-AX5i.book Page 14 Friday, May 23, 2003 6:33 PM