Filter
Top Products
Basic Operation
51
En
BASIC
Listening with ACOUSTIC CAL EQ
You can listen to the soundtrack with the ACOUSTIC CAL EQ you set automatically when you did the AUTO
SURROUND SETUP (page 13) or you set manually on (page 100). To do so follow the instructions below.
1 Press the ACOUSTIC EQ button.
Each press switches ACOUSTIC CAL EQ between ALL CH
ADJUST, FRONT ALIGN, CUSTOM 1, CUSTOM 2 and OFF.
When ACOUSTIC EQ is being applied the MCACC indica-
tor lights.
Memo:
• After completing the AUTO SURROUND SETUP
(page 13) ACOUSTIC EQ ON (ALL CH ADJUST) is set
automatically.
• You can’t turn on ACOUSTIC EQ on in MULTI CH IN or
SACD DIRECT mode.
• If you turn ACOUSTIC EQ on in DIRECT mode, the
receiver automatically switches to STEREO mode.
Digital Noise Reduction (DIGITAL NR Function)
To reduce extraneous noise switch on DIGITAL NR. This feature is effective with sources containing a lot of
background noise like cassette and video tape.
1 Press RECEIVER.
2 Press the DNR button on the remote
control.
Each press switches DIGITAL NR on or off.
When on, DNR lights in the display.
Memo:
• In cases described below, noise may not be reduced
even if DIGITAL NR is on.
· Sudden noise
· Extremely loud noise
· Signals that contain too many high frequencies
· Signals which are very clean to begin with.
• DIGITAL NR is effective at levels shown below for each
source.
STEREO
· Analog input ...................................................... 10-18 dB
· Digital input ....................................................... 10-15 dB
· AM/FM tuner ...................................................... 10-15 dB
MOVIE/MUSIC ....................................................... 6-10 dB
• Depending on the condition of the source, there may
not be a noticeable improvement in the quality of the
sound.
• You can’t use the DIGITAL NR mode with the THX CIN-
EMA, MULTI CH IN modes, DVD-A, SACD or source sig-
nals greater than 88.2 kHz over a digital connection
(including i.LINK).
• If you set the DIGITAL NR on in DIRECT mode the
receiver will switch to STEREO mode.
1
MCACC indicator
VSX-AX5i.book Page 51 Friday, May 23, 2003 6:33 PM