Filter
Top Products
64
Using Other Functions
Setting up the direct function
The direct function will not be necessary for most users. It is designed in case you have an external video source
connected to your TV (a video source that is not going through the VSX-29TX). For this explanation we'll call this the
"external video deck." You'd like to control external video deck with this unit's remote control so you've assigned it a
function button (for example purposes, the VCR 2 button). Yet, if you put the receiver in VCR 2 mode you'll get no
picture on your TV because the external video deck signal is not going through the VSX-29TX. To get around this
problem you set the DIRECT FUNCTION for VCR 2 to OFF. Now when you press VCR 2 function button you can control
the external video deck with the remote but the receiver does not go into VCR 2 mode.
1 Press REMOTE SETUP.
2 Press DIRECT FUNCTION.
3 Set the DIRECT FUNCTION of each external
source to OFF.
4 To leave the Direct Function mode press EXIT
repeatedly.
Resetting the Remote Control
The following operations allow you to erase the settings stored in the remote control.
Hold down both the STANDBY/ON button and
MUTE button and then push the RESET tab
under the battery cover on the back of the
remote control.
The default setting for all DIRECT FUNCTIONS is ON.
memo
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
Remote Setup
LCD
COMMANDER
MULTI OPERATION
DIRECT FUNCTION
PRESET RECALL
LEARNING
EXIT
1
2
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
Direct Function
DVD/LD
MD/TAPE 1
CD
ON
ONON
ON
TUNER
ONON
ON
TV/SAT
VCR 1
VCR 2
EXIT
4
3
MUTING
STANDBY/ON
+
ENTER
VCR2
TV
CONTROL
MUTING
MASTER VOLUME
SYSTEM
OFF
MULTI
OPERATION
STANDBY/ON
–
FUNCTION
RESET tab