Filter
Top Products
32
DIGITAL INPUT SELECT
In order to be able to use your digital equipment properly you need to assign digital inputs for each of the digital
components you connected. Match the DIGITAL IN buttons 1-4 with the digital jacks 1-4 in accordance with what
component is hooked up to each digital jack. Check the digital terminal numbers on the back of the receiver to make
certain what component is in which jack (if necessary, see p.10 for more on digital connections). The last button, the
AC-3 RF button, is specifically for a DVD/LD or LD player with an AC-3 RF output. If you connected one of these
components match this button to the component. If continuing from BASS PEAK LEVEL MANAGER go to step 1. If
starting fresh, complete steps 1-3 in “Setting Up for Surround Sound“ (p.23) first.
1 Press the DIGITAL INPUT SELECT button.
2 Press the DIGITAL INPUT SELECT button you want to
assign to select it. Each further press scrolls through the
possible components (functions) you can choose from.
Select the component you hooked up to that digital input
with that number.
This procedure assigns a digital function to the DIGITAL IN. Once one
function (for example DVD/LD) has been assigned its name disappears
from the possibilities on the remaining buttons because one function
cannot be assigned twice.
If a digital jack has nothing connected to it set the corresponding
button to OFF.
3 Repeat step 2 until all the digital in buttons correspond to
the components you connected.
4 If you hooked up a DVD/LD or LD player to the AC-3 RF
channel choose the proper component with the same
method described above.
5 Press SETUP OK to return the SYSTEM SETUP mode.
Hold the remote control pointed towards the receiver until you see the
“RECEIVED” display on the receiver.
If "ERROR" flashes in the display, perform the setup operations from
the first step again.
Initial Set Up
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
Digital In-Select
[DVD/LD]
[ CD ]
[ MD ]
[TV/SAT ]
[DVD/LD]
Digital-1
Digital-2
Digital-3
Digital-4
RF L
These settings will be displayed on your TV. (The settings pictured here
are the default settings.)
memo
• For the DIGITAL IN 1-4 buttons you can choose between DVD/LD,
CD, TV/SAT, MD/TAPE 1, VCR 1 and VCR 2 functions.
• For the AC-3 RF button you can choose between DVD/LD, TV/SAT,
VCR 1 and VCR 2 functions.
Remember, if you have a DVD/LD player or LD player you should
hook it up to the analog and digital jacks in addition to the AC-3 RF
connection described here.
Digital Input Select
DVD/LD
DIGITAL IN 1 DIGITAL IN 2 DIGITAL IN 3
DIGITAL IN 4 AC-3 RF
CD
DVD/LD
SETUP
OK
TV/SAT
MD
2,3
4
5
Digital Input Select
DVD/LD
DIGITAL IN 1 DIGITAL IN 2 DIGITAL IN 3
DIGITAL IN 4 AC-3 RF
CD
DVD/LD
SETUP
OK
TV/SAT
MD
1
System Setup
SPEAKER
SETTING
CROSSOVER
NETWORK
BASS PEAK LEVEL
MANAGER
DYNAMIC RANGE
CONTROL
DIGITAL INPUT
SELECT
MULTI ROOM
CHANNEL DELAY
CHANNEL LEVEL
EXIT
«
The remaining possible choices
for the digital inputs are shown
in the diagram on the right.