Filter
Top Products
24
Initial Set Up
SPEAKER SETTING
The following steps show you how to select the correct set up for the type and number of speakers you connected. If
continuing from the previous page go to step 1. If starting fresh, complete steps 1-3 on p.23 first.
1 Press SPEAKER SETTING.
Select a speaker setting mode (THX or FREE).
If you connected a complete set of THX speakers
Select THX and skip to step 3.
2 Specify the number and type of speakers you connected by
pressing on the speakers in the diagram.
1Select Large (three dots) or small (two dots) for the front speakers
depending on whether your front speakers can handle low bass sounds
and whether or not you hooked up a sub woofer.
2Select or deselect center speaker depending on whether or not you
hooked one up. Also choose the size, large or small.
3Select or deselect sub woofer depending on whether or not you hooked
one up. Also select PLUS if you have a sub woofer and want extra bass
sound
4Select or deselect surround (rear) speakers depending on whether or not
you hooked them up. Also choose large or small.
Depending on your choices the sound will be routed
differently. For more information see below.
FRONT (default setting is LARGE)
• Select small to send bass frequencies to the sub woofer.
• Select large if your speakers will reproduce bass frequencies effectively or
if you did not connect a sub woofer.
(If you select small for the front speakers the sub woofer will automatically
be switched YES. Also, the center and surround speakers cannot be set to
large if the front speakers are set to small. In this case, all bass frequencies
are sent to the sub woofer.)
CENTER (default setting is LARGE)
• Select large if your speaker will reproduce bass frequencies effectively.
• Select small to send bass frequencies to the other speakers or sub woofer.
• If you did not connect a center speaker, deselect it. In this case, the center
channel is output from the front speakers.
SURROUND (default setting is LARGE)
• Select large if your speakers will reproduce bass frequencies effectively.
• Select small to send bass frequencies to the other speakers or sub woofer.
• If you did not connect surround speakers deselect them. In this case, the
sound of the surround channels is output from the front and center
speakers.
SUB WOOFER (default setting is YES)
• Leave it selected if you connected a sub woofer.
• If you did not connect a sub woofer deselect it. In this case, the bass
frequencies are output from the front or surround speakers.
• Choose the PLUS setting if you want stronger reproduction of deep bass
sounds.
• If you select PLUS the bass frequencies that would normally come out the
front and center speakers are all routed to the sub woofer.
Speaker Setting
SETUP
OK
FREE
THX
1
System Setup
SPEAKER
SETTING
CROSSOVER
NETWORK
BASS PEAK LEVEL
MANAGER
DYNAMIC RANGE
CONTROL
DIGITAL INPUT
SELECT
MULTI ROOM
CHANNEL DELAY
CHANNEL LEVEL
EXIT
«
To confirm which speakers
represent, for example,
FRONT or CENTER speakers
in the LCD display see the
diagram below.
memo
Speaker Setting
SETUP
OK
FREE
THX
Front
L
Center Front
R
Sub
woofer
Surround
L
Surround
R
2-1
2-2 2-3
2-4