Filter
Top Products
22
You can press EXIT anytime to go back a screen or
repeatedly to escape this set up mode.
memo
4 Press each cross point in the middle to align the
remote control touch panel with the LCD panel
underneath.
This adjustment will make sure your remote control is calibrated
correctly.
When you've touched all four cross points the screen will show
the word "COMPLETE" and automatically return to the LCD
COMMANDER screen.
5 Decide which other adjustments you‘d like to make
and press those buttons. The different possibilities
are:
BEEP ON : When you have sent a command (pushed a button)
the remote control will beep once if the command is completed
or beep twice if the command is not possible. You can turn this
function ON or OFF by pushing this button (the default setting is
ON).
LCD CONTRAST : You can lighten or darken the contrast on the
remote control screen. Use the – /+ buttons to change the
contrast.
LCD TIMER : In order to save the battery a timer will
automatically turn the remote control off after a set amount of
time if no commands are entered. You can choose how long the
idle remote control will stay on before the timer turns it off. You
can set this function in a range of 10-60 seconds. The default
setting is 10 seconds. Use the – /+ buttons to adjust the number
of seconds for the timer setting.
(SYSTEM SETUP screens and REMOTE SETUP screens, as well
as the screens within those operations, are all fixed to stay on 60
seconds. If no command is entered they will turn off after 60
seconds.)
6 When finished with adjustments press the EXIT
button repeatedly to go back to the RECEIVER
screen.
Initial Set Up
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
Touch Panel Adjust
COMPLETE
EXIT
«
4
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
Touch Panel Adjust
EXIT
TOUCH CROSS POINT
5
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
LCD Commander
TOUCH PANEL
ADJUSTMENT
BEEP ON
LCD CONTRAST
EXIT
LCD TIMER :
10
SEC
6