Filter
Top Products
41
SET UP
OPERATION
Adjusting bass and treble (tone control)
Use BASS (+/–) or TREBLE (+/–) to adjust the low and high frequencies (the receiver must be in STEREO mode).
Press BASS (+/–) on the remote control’s Receiver
SUB screen or on the front panel to adjust the low
frequencies.
Press TREBLE (+/–) on the remote control’s Receiver
SUB screen or on the front panel to adjust the high
frequencies.
• The tone control can be adjusted in a range of ±6 dB.
• The tone control cannot be adjusted in STANDARD,
ADVANCED THEATER modes as well as DSP, THX,
EXTERNAL DECODER, DIRECT, and 96kHz settings.
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
memo
Listening in LOUDNESS mode
The LOUDNESS mode allows you to boost the bass in a signal. It is useful for listening to music at low volumes.
dB
STEREO
LOUDNESSSIGNAL
SELECT
ANALOG
SP
A
AUTO
VOLUME
Press LOUDNESS on the remote control’s Receiver
MAIN screen or on the front panel.
Each press switches LOUDNESS mode on or off.
memo
You can’t use the LOUDNESS mode with the THX, DIRECT or
EXTERNAL DECODER modes.
Basic Playback
Receiver
MAIN SUB
TREBLE
SYSTEM
SETUP
CH
LEVEL
INPUT
ATT.
BASS
EXTERNAL
5.1CH
TAPE 2
MONITOR
BASS +/– TREBLE +/–
TREBLE –/+BASS –/+
Receiver
MAIN SUB
DSP STEREO
THX
ADVANCED
THEATER
EFFECT
STANDARD
MIDNIGHT
LOUDNESS
DIRECT
SIGNAL
SELECT
DIGITAL
NR
/ dts
LOUDNESS
LOUDNESS