Filter
Top Products
50
Remote Control of Other Components
5 ~ 12 inches
memo
5 Point the two remote controls toward each other.
Press the button on the other remote control
corresponding to the operation you want to program.
LEARNING flashes in the display on the remote control. After the
process is complete and the command has been learned, OK will
appear at the top of the remote control LCD display. If NG (no good)
appears, it means that for some reason the command was not
learned.
Repeat steps 4 and 5 to teach the remote control of the VSX-29TX
all the commands from remote control.
6 Press EXIT to return to the LEARNING/SELECT
FUNCTION screen.
Start again from step 3 to program all your components in this
manner.
When you're done press EXIT repeatedly to return to the REMOTE
SETUP menu.
Some commands from other remote controls cannot be
learned, but in most cases the remotes just need to be moved
closer together or farther apart.
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
Learning
SELECT FUNCTION
EXIT
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
DVD:OK
1
2
4
7
8
9
5
6
3
SEARCH
MODE
TOP
MENU
SET UP
MENU
EXIT
0
C
10
6
5
EXIT
«
Locking the Settings
This feature allows you to lock the SYSTEM SETUP and REMOTE SETUP settings so that they cannot be changed
without unlocking them first. When they are locked you cannot enter the setting screen in these modes. The locking and
unlocking procedures are done by the same procedure.
1 In the SYSTEM SETUP or REMOTE SET UP screens
hold down the %¥fi buttons at the same time. A lock
symbol with a box around it will appear in the top bar
of the LCD screen.
2 Press the lock symbol while holding down the above
two keys. The setting will either lock or unlock
depending on the state it was previously in.
From that time, if the screen is locked the lock symbol will appear
when that screen is accessed.
The only exception to LOCKING THE SETTINGS is the LCD
COMMANDER settings in the REMOTE SETUP screen. They can
still be accessed even when the REMOTE SETUP screen is
locked.
memo
1
Lock symbol
+
ENTER
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
MUTING
MASTER VOLUME
SYSTEM
OFF
MULTI
OPERATION
STANDBY/ON
–
CH
+
FUNCTION
TV
CONTROL
VOL
–
CH
–
VOL
+
FUNCTION
BACK LIGHT
on off
Remote Setup
LCD
COMMANDER
MULTI OPERATION
DIRECT FUNCTION
PRESET RECALL
LEARNING
EXIT
2
+
ENTER
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
MUTING
MASTER VOLUME
SYSTEM
OFF
MULTI
OPERATION
STANDBY/ON
–
CH
+
FUNCTION
TV
CONTROL
VOL
–
CH
–
VOL
+
FUNCTION
BACK LIGHT
on off
Remote Setup
LCD
COMMANDER
MULTI OPERATION
DIRECT FUNCTION
PRESET RECALL
LEARNING
EXIT