Filter
Top Products
38
. Move the cross cursor to the motion detection
area to apply the sensitivity using the arrows
button (DCAB).
⁄0 Select the sensitivity using the jog dial from
the following.
OFF: Motion will not be detected
LOW: Low sensitivity
MID: Standard sensitivity
HIGH: High sensitivity
Note: Depending on the set positions of each motion
detection area, the sensitivity parameters for the motion
detection areas may be displayed overlapped with
each other.
⁄1 After completing the sensitivity settings for the
detection areas by repeating steps 9 and 10,
press the SETUP/ESC button.
⁄2 Press the SET button after selecting "VMD
MODE" by rotating the jog dial.
m Move the cross cursor using the arrows button
to a point to be determined as the end point of
the motion detection area.
Press the SET button to determine the selected point as the
end point of the motion detection area.
It is possible to set up to 4 motion detection areas by
repeating steps 6 and 7.
, Press the SET button after selecting "SENSI-
TIVITY" by rotating the jog dial.
Notes:
• Depending on the set positions of the detection areas,
the sensitivity indications of the detection areas may be
displayed overlapping each other.
• Depending on the set position of the detection area, a
part of the sensitivity indication of the detection area
may not be displayed.
R
2
R
1
LOGOUT
MONITOR1
MONITOR2
5
9
2
6
10/0
1413
3
7
11
SHIFT SEQ
COPY
DISK SELECT
EL-ZOOM
TEXT
LOGOUT
4
8
12
OSD
MARK
1
15 16
BUSY
316
REV FWD
STOP
PLAY PAUSE
REC
-
REC STOP
SEARCH
SETUP
/ESC
PAN/TILT
SLOW
A-B
REPEAT
GOTO
LAST
LISTED
ZOOM/
FOCUS
IRIS
PRESET
/AUTO
SET
–
+
PAN/
TILT
m,⁄2 ,⁄0⁄2
m.
⁄1