Filter
Top Products
175
• Check the host registration setting. When host authentica-
tion is set to ON, you cannot establish the connection
from computers other than the PC registered as the host.
Check item/Remedy
Problem
Page
The available disk space of
HDD is not displayed.
The available disk space of
HDD is not displayed on the
right bar.
Cannot establish a connection
via the network.
Response or Image update
takes time.
The power cord insulation is
damaged.
The power cord, plug and con-
nectors get hot during use.
The power cord gets hot when
bent or stretched.
Inspect the power cord, power plug and connectors periodically.
• Check if "Disk End Mode" is set to STOP.
• Check if the "Disk End Mode" is set to STOP.
• Check the network settings of the unit and PC.
• Check if the network is crowded.
• The power cord, plug and connectors are worn out. This may result in electric
shock or a fire. Unplug the power plug from the AC outlet immediately, and
refer to qualified service personnel.
• Check if there is a partition in the HDD.
• Check if there is a partition in the HDD.
Refer to p. 136.
Refer to p. 136.
Refer to the
Network Setup
Instructions (PDF).
–
Refer to p. 108
and 133.
–
–
Rebooting of the unit occurs
while displaying the splash
startup screen.
–
When the unit fails to find all of the connected extension units
(WJ-HDE300 series) previously mounted for the following rea-
sons, it may take time to start up because the unit will be
restarted while displaying the splash startup screen. They are
normal operations.
• When dedicated cables connecting the unit and the extension
units are not firmly connected or detached
• When all of the extension units previously mounted are
disconnected