Filter
Top Products
43
Note: To monitor the tape while it
is copying, adjust
MASTER VOL-
UME
(or
MASTER VOL
– or
MAS-
TER VOL
+ on the remote control)
to a comfortable listening level.
6. To stop copying, press
STOP/
EJECT
on both decks.
Notes:
• If the cassette tape in Deck 1
stops before the tape in Deck 2,
the cassette tape in Deck 2 con-
tinues to play at normal speed.
• If the cassette tape in Deck 2
stops before the tape in Deck 1,
Deck 1 records silence. Press
STOP/EJECT
on Deck 1 when
Deck 2 stops.
• If the original tape was recorded
using Dolby NR, the copy also has
Dolby NR, regardless of the posi-
tion of the
DOLBY NR
switch. If the
tape you copy does not have
Dolby NR, you cannot add it to the
tape you record.
Dubbing (Copying) CDs
1. Press
CD
.
2. If you want to record a program of
CD selections, follow the steps in
“Programming and Playing a
Sequence” on Page 36 to pro-
gram the CD playback.
3. Load a blank cassette tape, or
one you want to record over, into
Deck 1.
4. Press
PLAY
on Deck 1, wait for
the blank tape to play past the
tape leader (about 8 seconds),
then press
STOP/EJECT
on Deck
1.
5. Select the CD you want to record
from, then press
PLAY/PAUSE
on
the CD changer (or
CD
on the
remote control) twice to pause the
CD.
6. On Deck 1, press
PAUSE
then
RECORD
.
RECORD
and
PLAY
on
Deck 1 automatically lock down.
Caution: Do not force down
RECORD
. This can damage the
recording mechanism.
7. Simultaneously press
PAUSE
on
Deck 1 and
PLAY/PAUSE
on the
CD changer (or
CD
on the
remote control). The CD starts
playing from Track 1 or at the
beginning of a programmed
sequence, and the cassette
records until it reaches the end of
the side.
8. When you finish recording, press
STOP
on the CD changer, then
press
STOP/EJECT
on the tape
deck.
Press
STOP/EJECT
again to open
the cassette compartment and
remove the cassette tape.
t
t
13-1293.fm Page 43 Wednesday, July 14, 1999 6:49 PM