Filter
Top Products
HD-5MD/EN
78
Knowledge
CountermeasuresMeaningDisplay indication
MD section (list of displayed messages)
÷ Insert a minidisc.
÷ Digital recording is not possible.
÷ Record after switching the recording mode
to "ANALOG".
÷ Connect the square optical connector cor-
rectly.
÷ Connect an external source with a sam-
pling frequency suitable for this unit.
÷ Replace by a minidisc for recording.
÷ It is not possible to record 256 titles or more
onto one minidisc.
÷ Refer to "In regard to umber of characters
which can be entered".
÷ For playback, replace by a recorded minidisc.
÷ This is no defect.
÷ This is no defect.
÷ Perform "ALL ERASE". When this is not
possible, replace the disc.
÷ Perform editing within the limitations.
÷ Press the 0 key and remove the disc.
÷ Editing will be executed when the ENTER
key is pressed.
÷ Bring the minidisc to recordable condition
(cancel the protection).
÷ Insert a minidisc for recording.
÷ Provide an audio digital signal as output
from the connected external source.
÷ Start double-speed recording after the indi-
cated time has elapsed.
÷ Replace by a minidisc which can be played
back.
÷ Set the LP: Stamp function to OFF.
NO DISC
SCMS
UNLOCK
DISC FULL
FULL
BLANK DISC
READING
MD WRITING
UTOC ERROR
CAN'T EDIT
"ok" is flashing.
PROTECTED
PLAY ONLY
NOT AUDIO
WAIT XX min.
CAN'T PLAY
PL: SET
÷ No minidisc inserted.
÷ Digital copying of a source with digital copy
prohibition by SCMS has been tried.
÷ The square optical connector has become
disconnected or the connection is imper-
fect.
÷ An external source with a sampling fre-
quency other than 38 kHz, 44.1 kHz, is 48
kHz is connected.
÷ There is no recordable area.
÷ Recording of the 256th title has been tried.
÷ Title input in excess of the max. character
number has been tried.
÷ This is a blank minidisc with nothing re-
corded on it.
÷ TOC *1, UTOC *2 information is being
read.
÷ Various information is being written at the
tome of editing or recording.
÷ The TOC *1, UTOC *2 contents are abnor-
mal.
÷ Deletion of too short titles or other editing
exceeding the limitations has been tried.
÷ The disc has been removed after recording
or editing and the editing information has
not been recorded.
÷ This is the confirmation method asking "Is
it OK to execute editing?".
÷ The minidisc is write-protected (PROTECT).
÷ This is a play-only minidisc.
÷ The input is a digital signal other than an
audio signal.
÷ After the start of CD double-speed record-
ing, double-speed recording of the same
disc has been tried within 74 minutes.
÷ Playback of a minidisc which cannot be
played because it is unrecorded or for other
reasons has been tried.
÷ Title input processing is performed with an
increase in the track number.
¢
d
fi
!
„
I
s
*1: All minidiscs have information called TOC (Table of Contents) recorded in addition to the audio signal.
The TOC corresponds to the table of contents of a book, and it contains the information which cannot be
rewritten out of the number of titles, the playback time, character information, etc.
*2: The information characteristic for a minidisc for recording, other than the TOC, is called UTOC.
This UTOC contains the information which can be rewritten out of the number of titles, the playback time,
character information, etc.