Filter
Top Products
HD-5MD/EN
71
Knowledge
Important Items
1 Remove the CD and MD from the unit.
2 Press the CD 6 key.
3 Press the MD 6 key.
4 Wait for some time and verify that the dis-
play appears as above.
5 Wait a few seconds and turn the unit OFF.
Note related to transportation and movement
Before transporting or moving this unit, carry out
the following operations.
Maintenance
Reference
Maintenance of the unit
When the front panel or case becomes dirty, wipe with
a soft, dry cloth. Do not use thinner, benzine, alcohol,
etc. for these agents may cause discoloration.
Do not use contact cleaners because it could cause a
malfunction. Be specially careful not to use contact
cleaners containing oil, for they may deform the
plastic component.
In regard to contact cleaner
Condensation (of dew) may occur inside the unit when
there is a great difference in temperature between this
unit and the outside.
This unit may not function properly if condensation oc-
curs. In this case, leave the unit for a few hours and
restart the operation after the condensation has dried
up.
Be specially cautious against condensation in a follow-
ing circumstances:
When this unit is carried from one place to another
across a large difference in temperature, when the hu-
midity in the room where this unit is installed in-
creases, etc.
Caution on condensation
Memory backup function
Stored contents which are cleared immediately
when power plug is unplugged from power outlet :
Clock display
N.B. function
Stored contents which will back-up after power
plug is unplugged from power outlet:
State of power (on or standby), A, P, S, Last input
selection, AUX level, Volume control value, Balance
control, Receiving band, Frequency, Preset station,
Program Timer, TONE
MD section
When the power is off (standby) or the power
cable is disconnected from the receptacle, the
memory contents will be held for about three
days. In case of an extended power failure, dis-
connection of the power cable, etc., the informa-
tion in regard to recording or editing (recorded
when the minidisc is removed) may be lost or
destroyed before recording to the minidisc. Once
this information has been lost, it cannot be re-
covered.
After recording or editing, always remove the
minidisc to have this information recorded.