Filter
Top Products
1-8 If You Have Problems
If You Have Problems
After connecting your CD-Writer Plus drive and turning on your
computer, the computer should start (boot) as it normally does. If it does
not, check the following items:
■ Is the computer power plugged in?
■ Is each device plugged in and turned on?
■ Are all cables properly plugged into the back of your computer and
the CD-Writer Plus drive?
■ Try turning off your computer. Wait at least 20 seconds before turning
it back on.
Installing the Software for Windows 95 or
Windows NT 4.0
After the CD-Writer Plus drive is attached to your computer, you are
ready to install the application software.
NOTE: You must run the installation program. The installation program
converts the files from the CD into a usable format.
If your computer DOES NOT have a CD-ROM drive:
1. To get your CD-Writer Plus started right away, insert the diskette labeled
Driver Installation into your floppy drive.
2. Click the Start button on the task bar, select Run.
3. Type
A:\SETUP (where A: is your floppy drive’s letter), and press ENTER.
The parallel port driver files are installed. This may take several minutes
and your mouse cursor will not move.
4. Windows NT only: Reboot your computer before continuing.
5. Insert the CD labeled “Software Disc 1” into your new CD-Writer Plus
drive and proceed with step 2 in the next procedure.
NOTE: For information about inserting a CD into the CD-Writer Plus drive,
see “Inserting a CD” on page 2-1.