Filter
Top Products
13258 11/01
73
DSP Usage
Allows displaying the current DSP usage in MIPS.
From Remote From Front Panel Action
1
(PAUSE) or
(STOP)
(UP) or (DOWN) move to DSP Usage
2
SEL or ENTER
↵
(ENTER)
activate DSP USAGE
3
(PAUSE) or
(STOP)
(UP) or (DOWN) display currently used DSP MIPS
RS-232 Control Port
Configure the advanced computer interface control port on your processor. For further information concerning RS-
232 operation, see BKC-DIP for the computer interface protocol, and the AVR202 Plus and Reference 20 Plus
device specific appendix's.
RS-232 port setup -
From Remote From Front Panel Action
1
(PAUSE) or
(STOP)
(UP) or (DOWN) move to RS-232 Control Port
2
SEL or ENTER
↵
(ENTER)
activate RS-232 PORT SETUP
3
(PAUSE) or
(STOP)
(UP) or (DOWN) move to Port
4
X
(REW) or
W
(FF)
VOLUME KNOB select Enabled or Disabled
ADVANCED SYSTEM SETUP
1 Zone 1 Setup 'A'
2 Zone 2 Setup 'B'
3 Power On Titles
4 Control Out
5 Security Options
6 DSP Usage
7 RS-232 Control Port
next item SEL select
MENU setup system
6 DSP Usage
DSP USAGE
1 Utilized DSP
Processing Power
XXX MIPS
MENU advanced setup
1 Utilized DSP
Processing Power
XXX MIPS
ADVANCED SYSTEM SETUP
1 Zone 1 Setup 'A'
2 Zone 2 Setup 'B'
3 Power On Titles
4 Control Out
5 Security Options
6 DSP Usage
7 RS-232 Control Port
next item SEL select
MENU setup system
7 RS-232 Control Port
RS-232 PORT SETUP
1 Port Enable
2 Baud Rate 9600
3 Echo Enable
4 Update Enable
5 Receive ID 0
6 Transmit ID 0
next item SEL select
MENU advanced setup
1 Port Enable