Statistics Commands
91
VRRP statistics
Virtual Router Redundancy Protocol (VRRP) support on the HP 10GbE switch provides redundancy
between routers in a LAN. This is accomplished by configuring the same virtual router IP address and ID
number on each participating VRRP-capable routing device.
One of the virtual routers is then elected as the master, based on a number of priority criteria, and
assumes control of the shared virtual router IP address. If the master fails, one of the backup virtual routers
will assume routing authority and take control of the virtual router IP address.
When virtual routers are configured, you can display protocol statistics for VRRP:
The following command displays statistics for the VRRP LAN:
show ip vrrp counters
Command mode: All except User EXEC
>> Layer 3 Statistics# vrrp
VRRP statistics:
vrrpInAdvers: 0 vrrpBadAdvers: 0
vrrpOutAdvers: 0
vrrpBadVersion: 0 vrrpBadVrid: 0
vrrpBadAddress: 0 vrrpBadData: 0
vrrpBadPassword: 0 vrrpBadInterval: 0
The following table describes the VRRP statistics.
Table 65 VRRP statistics
Field Description
vrrpInAdvers
The total number of VRRP advertisements that have been received.
vrrpOutAdvers
The total number of VRRP advertisements that have been sent.
vrrpBadVersion
The total number of VRRP advertisements that had a bad version number.
vrrpBadAddress
The total number of VRRP advertisements that had a bad address.
vrrpBadPassword
The total number of VRRP advertisements that had a bad password.
vrrpBadAdvers
The total number of VRRP advertisements received that were dropped.
vrrpBadVrid
The total number of VRRP advertisements that had a bad virtual router ID.
vrrpBadData
The total number of VRRP advertisements that had bad data.
vrrpBadInterval
The total number of VRRP advertisements that had a bad interval.
