Configuration Commands
138
Table 112 Static FDB Configuration commands
Command Description
mac-address-table static all
[<interface>|<VLAN>|<port>]
Clears specified static FDB entries from the forwarding database, as
follows:
• Interface
• MAC address
• VLAN
Command mode: Global configuration
Trunk configuration
Trunk groups can provide super-bandwidth connections between switches or other trunk capable devices.
A trunk is a group of ports that act together, combining their bandwidth to create a single, larger port. Up
to 12 trunk groups can be configured on the switch, with the following restrictions.
• Any physical switch port can belong to no more than one trunk group.
• Up to six ports can belong to the same trunk group.
• All ports in a trunk must have the same configuration for speed, flow control, and auto negotiation.
• Trunking from other devices must comply with Cisco® EtherChannel® technology.
NOTE: See the HP 10Gb Ethernet BL-c Switch Application Guide for information on how to use port
trunks.
The following table describes the Trunk Group Configuration commands.
Table 113 Trunk Group Configuration commands
Command Description
portchannel {<1-12>} port
{<port number>}
Adds a physical port to the current trunk group.
Command mode: Global configuration
no portchannel {<1-12>} port
{<port number>}
Removes a physical port from the current trunk group.
Command mode: Global configuration
portchannel {<1-12>} enable
Enables the current trunk group.
Command mode: Global configuration
no portchannel {<1-12>} enable
Disables the current trunk group.
Command mode: Global configuration
no portchannel {<1-12>}
Removes the current trunk group configuration.
Command mode: Global configuration
show portchannel {<1-12>}
Displays current trunk group parameters.
Command mode: All
