Information Commands
19
Information Commands
Introduction
You can view configuration information for the switch in the ISCLI. This chapter discusses how to use the
ISCLI to display switch information.
The following table describes general information commands.
Table 6 Information commands
Command Usage
show sys-info
Displays system information.
Command mode: All
show layer2 information
Displays Layer 2 information.
Command mode: All
show layer3 information
Displays Layer 3 information.
Command mode: All
show rmon
Displays Remote Monitoring Information.
Command mode: All
show interface link
Displays configuration information about each port, including:
• Port number
• Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
• Duplex mode (half, full, or any)
• Flow control for transmit and receive (no, yes, or any)
• Link status (up or down)
Command mode: All except User EXEC
show interface information
Displays port status information, including:
• Port number
• Whether the port uses VLAN tagging or not
• Port VLAN ID (PVID)
• Port name
• VLAN membership
Command mode: All except User EXEC
show geaport
Displays GEA port mapping information, used by service personnel.
Command mode: All
show sfp
Displays the status of the Small Form Pluggable (SFP) module on each Fiber
External Port.
Command mode: All
show ufd
Displays Uplink Failure Detection information.
Command mode: All
