Configuration Commands
139
Layer 2 IP Trunk Hash configuration
Trunk hash parameters are set globally for the HP 10GbE switch. You can enable one or two parameters,
to configure any of the following valid combinations:
• SMAC (source MAC only)
• DMAC (destination MAC only)
• SIP (source IP only)
• DIP (destination IP only)
• SIP + DIP (source IP and destination IP)
• SMAC + DMAC (source MAC and destination MAC)
The following table describes the IP Trunk Hash Configuration commands.
Table 114 IP Trunk Hash Set commands
Command Description
portchannel hash source-mac-
address
Enable or disable trunk hashing on the source MAC.
Command mode: Global configuration
portchannel hash destination-mac-
address
Enable or disable trunk hashing on the destination MAC.
Command mode: Global configuration
portchannel hash source-ip-
address
Enable or disable trunk hashing on the source IP.
Command mode: Global configuration
portchannel hash destination-ip-
address
Enable or disable trunk hashing on the destination IP.
Command mode: Global configuration
portchannel hash source-
destination-ip
Enable trunk hashing on the source and destination IP.
Command mode: Global configuration
portchannel hash source-
destination-mac
Enable trunk hashing on the source and destination MAC address.
Command mode: Global configuration
show portchannel hash
Display current trunk hash configuration.
Command mode: All
