Configuration Commands
178
Remote Monitoring configuration
Remote Monitoring (RMON) allows you to monitor traffic flowing through the switch. The RMON MIB is
described in RFC 1757.
The following table describes the basic RMON Configuration commands. The following sections provide
more detailed commands.
Table 166 RMON commands
Command Description
show rmon
Displays the current RMON configuration.
Command mode: All
RMON history configuration
The following table describes the RMON History commands.
Table 167 RMON History commands
Command Description
rmon history <1-65535>
interface-oid <1-127
characters>
Configures the interface MIB Object Identifier. The IFOID must correspond
to the standard interface OID, as follows: 1.3.6.1.2.1.2.2.1.1.x
where x is the ifIndex (1-16, 18-21)
The interface OID can have a maximum of 127 characters.
Command mode: Global configuration
rmon history <1-65535>
requested-buckets <1-65535>
Configures the requested number of buckets, which is the number of
discrete time intervals over which data is to be saved.
NOTE: The maximum number of buckets that can be granted is 50.
The range is from 1 to 65535. The default is 30.
Command mode: Global configuration
rmon history <1-65535>
polling-interval <1-3600>
Configures the time interval over which the data is sampled for each
bucket.
The range is from 1 to 3600 seconds. The default value is 1800 seconds.
Command mode: Global configuration
rmon history <1-65535> owner
<1-127 characters>
Enter a text string that identifies the person or entity that uses this history
index.
The owner can have a maximum of 127 characters.
Command mode: Global configuration
no rmon history <1-65535>
Deletes the selected history group.
Command mode: Global configuration
show rmon history
Displays the current RMON History parameters.
Command mode: All
