Configuration Commands
106
Table 78 SSHD Configuration commands
Command Description
no ssh enable
Disables the SSH server. This is the default for the SSH server.
Command mode: Global configuration
show ssh
Displays the current SSH server configuration.
Command mode: All
RADIUS server configuration
NOTE: See the HP 10Gb Ethernet BL-c Switch Application Guide for information on RADIUS.
The following table describes the RADIUS Server Configuration commands.
Table 79 RADIUS Server Configuration commands
Command Description
[no] radius-server primary-host
<IP address> key <1-32 characters>
Sets the primary RADIUS server address and shared secret
between the switch and the RADIUS server(s).
Command mode: Global configuration
[no] radius-server secondary-host
<IP address> key <1-32 characters>
Sets the secondary RADIUS server address and shared secret
between the switch and the RADIUS server(s).
Command mode: Global configuration
radius-server port <UDP port
number>
Enter the number of the User Datagram Protocol (UDP) port to be
configured, between 1500-3000. The default is 1645.
Command mode: Global configuration
radius-server retransmit <1-3>
Sets the number of failed authentication requests before switching
to a different RADIUS server. The range is 1-3 requests. The
default is 3 requests.
Command mode: Global configuration
radius-server timeout <1-10>
Sets the amount of time, in seconds, before a RADIUS server
authentication attempt is considered to have failed. The range is
1-10 seconds. The default is 3 seconds.
Command mode: Global configuration
[no] radius-server telnet-backdoor
Enables or disables the RADIUS back door for
telnet/SSH/HTTP/HTTPS. This command does not apply when
secure backdoor is enabled.
Command mode: Global configuration
[no] radius-server secure-backdoor
Enables or disables the RADIUS back door using secure password
for telnet/SSH/HTTP/HTTPS. This command does not apply when
backdoor (telnet) is enabled.
Command mode: Global configuration
radius-server enable
Enables the RADIUS server.
Command mode: Global configuration
