Filter
Top Products
59
GB
Additional Information
Menu item Sub-item Function Parameters Factory setting Reference page(s)
F.in — Sets the duration of Fade-in Play and Recording. 1.0 to 15.0s 5.0s 45
F.out — Sets the duration of Fade-out Play and Recording. 1.0 to 15.0s 5.0s 45
Pitch — Changes the playback speed by auto steps. –48 to +2 0 43
Pfine — Fine controls the playback speed. –98.5 to +12.5% 0.0% 44
Sleep — Sets the duration of Sleep Timer. 30/60/90/120min 60min 45
Sleep — Turns Sleep Timer on or off. On/Off Off 45
Keyboard ? Type Selects the type of the keyboard connected to the deck. US/JP US 49
Assign ?
Assigns a character to the keyboard connected to the deck.
——52
Clock Set ? — Sets the clock. — — 8
To recall a factory setting
Press CLEAR while selecting the parameter.
Self-Diagnosis Function
The deck’s self-diagnosis function automatically checks the condition of the MD deck when an err or occurs, then issues a
three-digit code and an err or message on the display . If the code and message alternate , find them in the following table
and perform the indicated countermeasur e. Should the problem persist, consult your nearest Sony dealer .
Three-digit code/Message Cause/Remedy
C11/Protected The inserted MD is record-protected.
, Take out the MD and close the record-protect slot (page 19).
C13/REC Error The recording was not made properly.
, Set the deck in a stable surface, and repeat the recording procedure.
The inserted MD is dirty (with smudges, fingerprints, etc.), scratched, or substandard in quality.
, Replace the disc and repeat the recording procedure.
C13/Read Error The deck could not read the TOC on the MD properly.
, Take out the MD and insert it again.
C14/Toc Error The deck could not read the TOC on the MD properly.
, Insert another disc.
, If possible, erase all the tracks on the MD (page 35).
C71/Din Unlock The sporadic appearance of this message is caused by the digital signal being recorded. This will not affect
the recording.
While recording from a digital component connected through the DIGITAL IN connector, the digital
connecting cable was unplugged or the digital component turned off.
, Connect the cable or turn the digital component back on.