Filter
Top Products
76
Troubleshooting (continued)
“—OVER—” appears.
• Press and hold m or press . to return to
the desired playing position.
“OVER” lights up during recording.
• Set the volume of the connected component
lower (see page 41).
Recording or editing was done, but the
TOC is not updated.
• MD recording and editing contents are
recorded to the MD when the MD is removed,
so make sure you remove the MD after
recording or editing (see pages 32 and 44).
Recording is not possible.
• Remove the MD and slide the tab to close the
slot (see page 32).
• Connect the optional A/V component
properly (see page 69).
• Switch to another sound source.
• Replace the MD with a recordable MD, or use
Erase Function to erase unnecessary tracks
(see page 47).
• Start recording over from the beginning.
The sound from an MD you recorded is
too low (or too high).
• Readjust the recording level (see page 41).
MD Deck
An MD cannot be inserted.
• Insert the MD with the arrow side up and the
arrow pointing toward the deck.
The controls do not work.
• Replace the MD with a new one.
• Retry the operations after “TOC” or
“STANDBY” turns off.
Play does not start.
• Replace the MD.
• Insert the MD and leave the system turned on
for a few hours until the moisture evaporates.
• Press MD NX to start play.
The sound skips.
• Replace the MD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the
system, or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause
the sound to skip.
• Insert the disc and wait for 10 to 20 minutes
with the system turned on.
Play does not start from the first track.
• Press PLAY MODE repeatedly until “PGM”
or “SHUFFLE” disappears to return to normal
play.