Filter
Top Products
69
Other Features/Connecting optional
components
To change the setting
Start over from step 1.
To check the setting/activate
the timer
1 Press CLOCK/TIMER SELECT.
2 Press . or > to select either “MD REC”
or “TAPE REC”, then press ENTER/YES.
To cancel the timer
Press CLOCK/TIMER SELECT and press .
or > repeatedly until “TIMER OFF” appears.
Then press ENTER/YES.
Tip
When you record from the radio, the station name
(see page 63, or frequency when the station is not
labeled), the start time and the stop time are
automatically recorded on the MD.
Notes
• The Smart Space and Level Synchro Recording
functions do not operate.
• You cannot activate Daily Timer and the recording
timer at the same time.
• Do not operate the system from the time the system
turns on until the recording starts (about 30 seconds
before the preset time).
• When you record on a brand new MD, the first
15 seconds are not recorded.
• If the system is on about 30 seconds before the
preset time, the timer-recording will not be
activated.
• The volume is reduced to minimum during
recording.
Connecting optional
components
Connecting optional A/V
components
To enhance your system, you can connect optional
components. Refer to the operating instructions of
each component.
Connecting audio components
Connecting an MD deck and a
tape deck for analog recording
You can connect an MD deck and a tape deck to
the system with commercially available audio
cords. Be sure to match the color-coded pins to the
appropriate jacks.
To the audio input jacks on the
MD deck or the tape deck
continued