Filter
Top Products
11
Basic Operations
With the arrow
pointing toward
the deck
2 Press CD Z and place a CD on the disc
tray.
6 Press ENTER/START again.
Recording starts.
When the recording is completed, the CD
player and the MD deck stop automatically.
To stop recording
Press CD x or MD x.
Tips
• The track numbers of the CD are recorded on to the
MD automatically.
• Depending on the disc, CD TEXT information may
also be recorded (except when you record on an
MD and a tape at the same time). If “CD-TEXT”
flashes during recording, press NAME EDIT on the
remote, and then press ENTER/YES on the remote
to record the title of the current track. (If
“CD-TEXT” is lit, it is automatically recorded.)
Note
If “Cannot SYNC” appears, a disc is not loaded or
you cannot record on that MD (see page 79).
If the MD becomes full during
recording
The CD player and the MD deck stop
automatically.
Before pulling out the power
cord
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the system. Do not pull out the power cord
before updating the TOC (while “TOC” is lit) or
while updating the TOC (while “TOC” or
“STANDBY” is flashing) to ensure a complete
recording.
continued
1 Insert a recordable MD.
With the label side up, and the
shutter on the righthand side
With the label
side up. When
you play a CD
single (8 cm
CD), place it on
the inner circle
of the tray.
3 Press CD Z to close the disc tray.
4 Press SYNCHRO REC repeatedly until
“CD-MD SYNC” appears.
5 Press ENTER/START.
The MD deck stands by for recording and the
CD player pauses for play.