Filter
Top Products
37
The MD Deck — Recording
Marking track numbers
You can mark track numbers as follows:
• Automatically during recording
Track numbers are automatically marked as on the
original source during recording from this
system’s CD player. Use the Level Synchro
Recording function to automatically mark track
numbers during recording from this system’s tuner
or components connected to the VIDEO IN jack.
However, you cannot mark track numbers
automatically if the sound source to be recorded is
noisy (e.g., tapes or radio programs) or during
timer-recording.
• At any point during recording
You can mark track numbers during recording of
any source.
• After recording
Use the Divide Function (see page 52).
Marking track numbers
automatically during
recording
— Level-Synchro Recording
The Level Synchro Recording function is factory
set to on, so the track numbers are automatically
marked. If “LEVEL-SYNC” does not appear
during recording, turn on the Level Synchro
Recording as follows. Track numbers are
automatically marked when the input signal is
continuously below a certain level for more than
2 seconds and then exceeds that level.
Note
You cannot mark track numbers automatically if the
sound source to be recorded is noisy (e.g., tapes or
radio programs).
2
1
x
.
>
N
`/1
X
M
m
3,7 4,5,6
4,5,6
4,5,6
8
1 Press FUNCTION repeatedly to switch
the function to TUNER.
To record from other components connected
to this system, select “VIDEO”.
2 Press MD REC z.
The MD deck stands by for recording.
3 Press MENU/NO on the remote.
4 Press . or > on the remote
repeatedly until “Setup ?” appears, then
press ENTER/YES on the remote.
continued