Filter
Top Products
71
Connecting optional components/Additional
Information
AM antenna
Connect a 6- to 15- meter insulated wire to the
AM antenna terminal. Leave the supplied AM
loop antenna connected.
Jack type A
Insulated wire (not
supplied)
Jack type B
Insulated wire (not
supplied)
Important
If you connect an external antenna, connect a
ground wire to the U terminal. To prevent a gas
explosion, do not connect the ground wire to a gas
pipe.
Additional Information
Precautions
On safety
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Unplug the system from the mains if it is not to be
used for an extended period of time.
To disconnect the power cord, pull it out by the
plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
system, unplug the system and have it checked by
qualified personnel before operating it any further.
• AC power cord (mains lead) must be changed only
at the qualified service shop.
• When you connect the power cord to the AC power
source, even if the power is off, the system begins
charging for remote and timer functions. Therefore
the surface of this unit become warm, this is
normal.
On placement
• Make sure the system fan is on during use.
Place the system in a location with adequate air
circulation, and do not place anything on top of the
system.
• Place the system in a location with adequate
ventilation to prevent heat build up.
• Do not place the system in an inclined position.
• Do not place the system in locations where it is;
– Extremely hot or cold
– Dusty or dirty
– Very humid
– Subject to vibrations
– Subject to direct sunlight.
continued