Filter
Top Products
Messages
lflhe lbllowing error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
AVLS • AVLS is set to "ON" so that the volume will not increase anymore.
-_" Set AVLS to "OFF" (page 59).
_, FULL • You tried to set the 21 st bookmark.
You can set up 1o20 bookmarks. Set bookmarks within 20.
BLANK • An MD with no recording on it is inserted.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
Wait until 1he mess3ge goes out (in rare cases, it may t_ke a
few minu|es).
CannotCHG • You tried 1o charge at a place where the temperatare is too high.
-_" Charge the baltery at a temper3ture of 5°C (+41 °F) to +40°C
(+I04°F).
Edit • The MD player is recording informalion (track start and end
position) from the memory to the disk.
Wait until lhis process is completed. Do not expose the player
to physical shock, nor disrupt power supply.
ERROR • There is 3n internal malfunction in the system.
-_" Restart the operation by doing steps 1to 3 on page 77. if the
message appears again, please consult your nearest Sony
dealer.
FULL
• The remaining recording time on the disc is 12 seconds (stereo), 24
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or
less.
-_" Replace the disc.
• You tried m enter more lhan 200 letters to label a single lrack or
disc.
• You tried to enter a total of more |has_ 1,700 letters tbr track or disc
names.
• You tried 1o create a 100th group.
-_" You can create only up |o 99 groups on a disc. Keep |he group
number wi|hin 99.
HiDCin * Voltage of the power supply is too high (The supplied AC power
adaptor or _he recommended car battery cord is not used).
Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD • The recorder is locked.
Slide HOLD against the arrow to unlock lhe recorder
(page 20).
78