Filter
Top Products
Symptom
Recording cannot be
done correctly.
Cause/Remedy
• Audio sources may not be securely connected.
Disconnect the audio sources once and connect them again
(pages 20, 23).
• There is no digital signal fl'om the portoble CD player.
When recording digitally from a portable CD plzyer, use the
AC power odaptor and disable the anti-skip function (such as
ESP) on the CD player (page 23).
• The analog recording was made using a connecting cord with an
attenuator.
Use a connecting cord without an attenuotor.
• Recording level is loo small to record (when adjusting the
recording level manually).
Pause the recorder and adjust the recording level (page 34).
• The power sources was disconnecied or a power outage occurred
during recording.
The recording result is not recorded on the disc. Make
recording again.
• The premastered MD is inserted.
Replace to the recordable MD.
• The remaining recordable time on the disc is 12 seconds or less
("FULL" appears).
Replace the disc.
• You tried to overwrtie a track which is checked out from the
computer. (Tracks that are checked out from the computer
cannot be overwrite. The recording stops automatically.)
Check back the checked out track into the computer.
Record fi'om the end of the disc.
Recording stops
automotically while
recording.
Stereo sound is heard • This is normal. During digital recording, the sound will be stereo
in the headphones/ in the headphones/earphones, even though the recorded sound is
earphones while monaural.
recording in
monaural.
Momentary noise is • Due to the special digital audio compression technology used in
heard when LP4 siereo mode, momentary noise moy occur on very rare
recording, occasions with certain sound sources.
Record in SP or LP2 mode.
The lid does not open • The lid does not open until "Edit" disappears in the display.
alter recording.
73