Filter
Top Products
44
US
1 Press ?/1 to turn off the
receiver.
2 While holding down the TONE
MODE and 2CH/A.DIRECT,
press ?/1 to turn on the
receiver.
3 Release the TONE MODE and
2CH/A.DIRECT after a few
seconds.
The “CLEARING” appears on the
display window for a while, then changes
to “CLEARED !”
Changes or adjustments made to the
settings are now reset to the defaults.
Note
It takes about one minute for the memory to be
cleared completely. Do not turn the receiver off until
“CLEARED !” appears on the display.
Insert two R6 (size-AA) batteries in the
RM-AAL041 remote control.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote control in an extremely hot
or humid place.
•Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• If you do not intend to use the remote control for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace or remove the batteries, the
programmed codes may be cleared. If this happens,
program the remote control codes again
(page 118).
Inserting batteries into the
remote control
RM-AAL041