Filter
Top Products
123
US
Using the Remote Control
1 Press MACRO 1 or MACRO 2 for
more than 1 second while
pressing RM SET UP.
The RM SET UP button flashes and one
of the input buttons lights up (as the
factory default setting, the BD/DVD
button lights).
2 Press the input button for the
equipment for which you want
to program the sequence of
operation(s).
3 Press the buttons you want to
program in the same sequence
as you want the operation(s) to
be performed.
You can program particular operations
using the following buttons.
The input button selected in step 2 flashes
twice, then lights up again.
4 Repeat steps 2 and 3 when you
want to program operations for
other equipment.
5 Press RM SET UP to finish the
programming process.
To cancel programming
Not pressing any button for 60 seconds cancels
the settings.
The previous command remains valid.
1 Press AMP.
The AMP button lights up, and then turns
off.
2 Press MACRO 1 or MACRO 2 to
start the macro.
The macro starts and execute the
commands in the order you assigned
them. While the commands are being
sent, the AMP button flashes and the RM
SET UP button lights up. When the
commands have been sent, the RM SET
UP and AMP buttons turn off.
To erase a programmed macro
1
Press MACRO 1 or MACRO 2 for more
than 1 second while pressing RM SET
UP to clear the stored macro.
The RM SET UP button flashes.
2 Press RM SET UP.
Settings stored as macro are cleared.
Setting remote control
codes that are not stored
in the remote control
Even if a remote control code is not one of the
presets stored in the remote control, it is
possible for the remote control to learn the
code using the learning function.
Program the sequence of the
operation
Press Operations to be
programmed
The input
button for more
than 1 second
Switches inputs.
MACRO 1 or
MACRO 2
Make a one second
interval. When you want
to make a longer
interval, press MACRO
1 or MACRO 2
repeatedly.
Starting macro play
continued