Filter
Top Products
ENGLISH
58
Press the CURSOR LEFT( )/ RIGHT( buttons to set the selected speaker as desired.
3
• Depending on your speaker type, you can select one of these
following speaker types.
LARGE: Select this when connecting speakers that can fully
reproduce sounds below crossover frequency.
SMALL: Select this when connecting speakers that can not fully
reproduce sounds below crossover frequency. When this is
selected, sounds below crossover frequency are sent to the
subwoofer or speakers which are set to LARGE(when not
using a subwoofer)
NONE: Select this when no speakers are connected. When this is
selected, sounds are sent to the speakers which are not set to
NONE.
2CH/1CH: Select the desired depending on the number of surround
back speakers.
YES/NO: Select the desired depending on whether a subwoofer is
connected or not.
Repeat the above steps and until the speakers are all set to the desired mode.
4
Continued
Notes :
• When speakers are set to "SMALL", you should set their crossover frequency correctly according to their
frequency characteristics. (For details, refer to "When selecting the SPEAKER CROSSOVER" on page 60.)
• When the "FRONT" is set to "SMALL", "CENTER", "SURROUND", "SURR BACK" cannot be set to
"LARGE" and "SUBWOOFER" is automatically set to "YES".
• When the "SURROUND" is set to "SMALL", "SURR BACK" cannot be set to "LARGE".
• When the power amplifier for surround back/room 2 channels is assigned to "ROOM 2", the "SURR BACK"
cannot be selected. (For details, refer to "When selecting the AMP ASSIGN" on page 49.)
When setting the speaker size by performing the auto setup.
If the speakers may not be detected properly because of incorrect connection, measurement environment,
or other factors, the speakers are set as follows :
• When a pair of speakers such as front, surround or surround back speakers are detected differently (i.e,
one is detected as "LARGE", the other as "SMALL"), both are automatically set to "SMALL".
• When only one surround speaker is detected, both are automatically set to "NONE".
• When only the surround back right speaker is detected, both are automatically set to "NONE".
In this case, connect that speaker to the SURROUND BACK/ROOM 2 LEFT speaker terminals and retry
the auto setup, then it will be automatically set to "1CH".
About the speaker size
• Select "LARGE" or "SMALL" not according to the actual size of the speaker but according to the speaker's
capacity for playing low frequency (bass sound below frequency set on the SPEAKER CROSSOVER
menu) signals.
• If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so
as not to damage the speakers) to determine the proper setting.
• When setting the speaker size by performing the auto setup, depending on whether the measured
crossover frequency of each speaker is lower or higher than 80 Hz, its size is automatically set to "LARGE"
or "SMALL". (For details, refer to "When selecting the SPEAKER CROSSOVER" on page 60.)