Filter
Top Products
26
ENGLISH
Operating a punch-through function
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, depending on the
selected punch-through mode, the punch-
through devices and the deleting mode
(“DELETE”) are selected.
• Then “OK” is displayed and the current punch-
through mode is displayed .
While “VOL” is displayed, press the
CURSOR UP( )/DOWN( ) buttons to
select the punch-through mode to be
erased, then press the ENTER button.
2
While the punch-through mode is
displayed, repeat the above steps
and to erase other punch-through
function under the same master device
mode.
4
Perform the steps and in
“Entering a setup code” procedure on
page 20 to select a master device and
the punch-through mode (“PUNCH”).
1
While the device is displayed, press
the CURSOR UP( )/DOWN( )
buttons to select the one punch-
through deleting mode(“DELETE”),
then press the ENTER button.
3
• While this remote control is set to control a
master device, aim the remote control at the
REMOTE SENSOR of the punch-through
device and press the desired button of the
programmed punch-through controls.
Example: When pressing “PLAY ( )” button.
Erasing the programmed puch-through
function
• Then the punch-through device is displayed on
the LCD screen.
• Then “VOL” is displayed on the LCD screen for
several seconds.
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, the mode changes as
follows:
VOL DELETE PLAY CH
• Then the device is displayed .
To erase punch-through functions
under other master device mode,
repeat the above steps to .
5