Filter
Top Products
9
6. CONNECTING PRE OUTS
• Use these jacks when adding additional
power amplifiers.
• Connect the PRE OUT jacks to the powered
speakers or the power amplifiers connected
to speakers respectively.
• When using only one surround back speaker,
connect the SURROUND BACK LEFT jack to
the power amplifier.
• To emphasize the deep bass sounds,
connect a powered subwoofer.
Notes :
• After installing the speakers, first adjust the
speaker settings according to your
environment and speaker layout (For details,
“SETTING THE SPEAKER/ROOM EQ
SETUP” on page 55.)
• According to speaker settings, some
channels of PRE OUTs cannot output audio
signals.
7. CONNECTING SYSTEM CONTROL
• Connect this jack to the DIGI-LINK jack of the
external Sherwood component that uses the
DIGI-LINK II or III remote control system.
8. CONNECTING DC TRIGGER OUT
• Connect a component to DC TRIGGER OUT
jack that allows DC 12V to turn on when a
specific input source is selected.
• For details, refer to the operating instructions
of the components to be connected.
• To link DC TRIGGER OUT with a specific
input source, refer to "When selecting the DC
TRIGGER" on page 54.
Note:
• This output voltage (12V d.c., 100mA) is for (status) control only, it is not sufficient for drive capability.
• When making DC TRIGGER connection, you should use the stereo mini cord, not a mono mini cord.
ENGLISH