Filter
Top Products
22
ENGLISH
• If the command has been learned successfully,
“OK” is displayed and then “SEL” is flickering.
• If “ERROR” is displayed and then “SEL” is
flickering, it means that for some reason the
command was not learned. In this case, repeat
the above steps and .
Notes :
• If an incorrect signal has been sent or, in some
cases, the command from other remote control
simply cannot be learned.
• In some “ERROR” cases, the remote controls
just need to be moved closer together or
farther apart.
Programing the commands from other
remote controls (LEARNING mode)
Press and hold down the ENTER
button and the desired one of the
DEVICE buttons for more than 2
seconds.
2
Place this remote control and other
remote control facing each other at a
distance of 5 to 15 cm (2 to 6 inches )
apart.
1
While “SEL” is flickering, on this remote
control, press the button corresponding
to the function to be learned.
Example: If the function to be learned is playback,
press the PLAY( ) button.
4
While “SEL” is flickering, repeat the
above steps and to program all
the commands you want to the buttons
on this remote control under the same
device mode.
6
Repeat the above steps to to
program the commands from a different
remote control.
7
Operate the newly programmed buttons
to make sure the learning function was
performed properly.
8
• Then “SEL” is flickering.
• If “SEL” goes off, start again from the above
step .
• If the setup codes are not available for your
component or you want to program a missing or
special function into one button of a device, the
learning function enables this remote control to
learn the commands from other remote controls.
• Then “READY” is displayed.
Note:
• You cannot program a function into some
buttons such as DEVICE, MACRO and LIGHT
buttons.
To exit from the setting mode, press any of the
DEVICE buttons.
• Then “LEARN” is displayed on the LCD screen
for several seconds
Note :
• During setting operation, to exit from the setting
mode, press any of the DIVICE buttons.
While “LEARN” is displayed, press the
ENTER button.
3
While “READY” is displayed, on the
other remote control, press the button
of the function to be learned.
5