Filter
Top Products
29
LISTENING TO A PROGRAM SOURCE
Operations
Before operation
Select the desired input source.
3
• Enter the standby mode.
• The POWER ON/STANDBY button
lights up in amber. This means that
the receiver is not disconnected from
the AC mains and a small amount of
current is retained to support the
operation readiness.
• To switch the power off, push the
POWER switch again.
Then the power is cut off and the POWER ON /
STANDBY button goes off.
• Each time this button is pressed, the speaker
mode changes as follows and the sound can
be heard from the speakers connected to the
selected front speaker terminals:
• When using the headphones for private listening, select the
Off mode to switch off the front speakers and all the others.
• Each time the "AUDIO" button on the front panel
is pressed, the input source changes as follows:
CD AUX TAPE
• Each time the "VIDEO" button on the front panel
is pressed, the input source changes as follows:
VIDEO 1 VIDEO 2 - - - VIDEO 5
• Each time the "BAND" button is pressed, the
band changes as follows:
FM STEREO FM MONO AM XM
When selecting the EXTERNAL IN as desired,
• Depending on the power amplifier setting for the
surround back channels and the surround back
speaker setting, "EXT. IN" is displayed and 8(/7/6)
separate analog signals from the component
connected to this input pass through the tone and
volume circuits only and can be heard from your
speakers.
• Press the EXTERNAL IN button or select the
desired input source to cancel the external in
function.
• These analog signals can be heard only, not
recorded.
Switch the desired front
speakers on.
2
Notes:
• Before operating this receiver with the supplied remote control, refer to "Universal Remote Controls" on page 17
for details about operation.
• Before operating this receiver, first set this unit as desired for optimum performance, doing the OSD menu
setting procedures. (For details, refer to "OSD Menu Settings" on page 47.)
In the standby mode, turn the power on.
1
• Each time the POWER ON/STANDBY button on
the front panel is pressed, the receiver is turned on
to enter the operating mode (the POWER ON/
STANDBY button lights up in blue) or off to enter
the standby mode(the POWER ON/STANDBY
button lights up in amber).
• On the remote control, press the POWER ON
button to enter the operating mode or press the
STANDBY button to enter the standby mode.
• In the standby mode, if the INPUT SELECTOR
button is pressed, the receiver is turned on
automatically and the desired input is selected.
ENGLISH