Filter
Top Products
25
ENGLISH
Programming a punch-through function
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, depending on the selected
punch-through mode, punch-through devices
and the one punch-through deleting mode
(“DELETE”) are selected as follows :
• In case of the volume punch-through,
AUDIO DELETE TV
• In case of the transport punch-through,
CD DELETE DVD VCR AUX
• In case of the channel punch-through,
TV DELETE SAT CABLE VCR
• Then “OK” is displayed and the current punch-
through mode is displayed.
While “VOL” is displayed, press the
CURSOR UP( )/DOWN( ) buttons to
select the desired punch-through mode
, then press the ENTER button.
2
Perform the steps and in
“Entering a setup code” procedure on
page 20 to select a master device and
the punch -through mode (“PUNCH”).
1
While the device is displayed, press the
CURSOR UP( )/DOWN( ) buttons to
select the desired punch-through
device, then press the ENTER button.
3
• The punch-through function allows the volume
controls, channel controls or transport controls
to link to a different device while a device is
controlled with this remote control as a master
device.
• For example, since this receiver will likely be
used as the sound system while watching TV,
you may want to use volume controls to operate
this receiver although this remote control is set
to control the TV.
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, the mode changes as
follows:
VOL : The volume punch -through mode
allows the “VOLUME / ” and
“MUTE” buttons to operate a different
device.
DELETE : All punch-through deleting
mode.
PLAY : The transport punch-through mode
allows the “ ”, “ ”, “ ”, “ ”, “ ”,
“
”, “ ” and “ ” buttons to
operate a different device.
CH : The channel punch-through mode
allows the “CHANNEL
/ ” and “CH.
LEVEL” buttons to operate a different
device.
• Then the device to which you can link the
selected punch-through mode is displayed.
• Then “VOL” is displayed on the LCD screen for
several seconds.
While the punch-through mode is
displayed, repeat the above steps
and to program other punch-through
function under the same master device
mode.
4
To program punch-through functions
under other master device mode,
repeat the above steps to .
5