Filter
Top Products
20
USING FUNCTIONS OF REMOTE CONTROL
Entering a setup code
• This remote control can control up to 8 different components.
• Before operating audio and video components other than this receiver with using this remote control, the setup
code for each component should be entered.
• For system remote control operation, “000” was stored previously in the memory of the device button “CD” for
Sherwood CD player, “DVD” for Sherwood DVD player, “AUX” for Sherwood tape deck and “TV” for Sherwood TV
respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in
such a case that its code does not work.
Find the setup codes according to the
type and the brand name of your
component, referring to “Setup Code
Table” on page 71.
2
Turn on the component you want to
operate
1
While “LEARN” is displayed, press the
CURSOR UP( )/DOWN( ) buttons to
select the setup code mode (“CODE”),
then press the ENTER.
4
• Then “LEARN” is displayed on the LCD screen
for several seconds.
Notes:
• The AUDIO button is unavailable for the audio
components other than this receiver.
• During setting operation, to exit from the setting
mode, press any of the DEVICE buttons.
• Then “OK” is displayed on the LCD screen.
• To be sure that the setup code is correct, press the
POWER ON (or STANDBY) button.
• If the setup code is correct, your component will be
turned off.
• When your component is not turned off, repeat the
above steps to , trying entering each code for
your component until you find one that works.
• If “NG” is displayed, retry entering the correct
setup code while “PRESET” and 3 digit number
are displayed.
• Setup code entry is the easiest way to program
this remote control for operating audio and
video components.
• Each time the CURSOR UP( )/DOWN( ) buttons
are pressed, the mode changes as follows :
LEARN DELETE MACRO
CODE PUNCH
• Then “PRESET” and 3 digit number are displayed.
• If “PRESET”, etc. go off, start again from the above
step .
Press and hold down both the ENTER
button and the desired one of the
DEVICE buttons for more than 2
seconds.
3
While “PRESET”, etc. are displayed, enter a 3 digit code and press the ENTER button,
aiming the remote sensor on the component.
Example: When entering "001".
5
ENGLISH