Filter
Top Products
19
LOADING BATTERIES
OPERATING COMPONENTS WITH REMOTE CONTROL
1
2
REMOTE CONTROL OPERATION RANGE
• Use the remote control within a range of
about 7 meters (23 feet) and angles of up
to 30 degrees aiming at the remote sensor.
Remove the cover.
Load four alkaline batteries (“AAA”
size, 1.5V) matching the polarity.
When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries
within several minutes after removing old batteries.
If the betteries are removed or have been exhausted for a longer period of time, memorized contents will be
cleared. Should this happen, you should memorize them again.
Enter the setup code for each
component other than this receiver.
For detalis, refer to “Entering a setup
code” on page 20.
Turn on the component you want to
operate.
1
Select the DEVICE button on the
remote control corresponding to the
component you wish to operate.
2
Aim the remote control at the
REMOTE SENSOR of the component
you wish to control and press the
button corresponding to the operation
you want.
3
4
+
+
+
ENGLISH
• When operating a Sherwood CD player or tape
deck using digi link system remote control, aim
the remote control at the REMOTE SENSOR
of this receiver.
However, to operate a Sherwood DVD player,
aim at the REMOTE SENSOR of the
corresponding component.
• Remove the batteries when they are not used
for a long time.
• Do not use the rechargeable batteries (Ni-Cd
type).
• Be sure to use alkaline batteries.