Filter
Top Products
21
• If any of buttons fails to operate as they
should, start from the step again to find the
correct setup code.
Repeat the above steps to for each of your other components.
7
Searching a setup code
Perform the steps and in
“Entering a setup code” procedure on
page 20 to select the setup code mode
(“CODE”).
2
Turn on the component you want to
operate.
1
While “PRESET” is displayed, press the
ENTER button to store the setup code.
4
Repeat the above steps to for
each of your other components.
6
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, the setup code is selected
one by one.
• If the selected code is correct, your component
will be turned off.
• When your component is not turned off, repeat
this step until you find one that works.
• In addition to enter a setup code using “Setup
Code Table” on page 71, it is also possible to
search through all the codes that are stored in
the library of this remote control.
• Then “OK” is displayed on the LCD screen.
While “PRESET” is displayed, search a
setup code, aiming the remote control
at the remote sensor on the
component.
3
Operate the component using the
corresponding function buttons.
5
Operate the component using the corresponding function buttons.
6
• If any of buttons fails to operate as they should , start from the step again to enter the correct setup code.
Notes:
• Manufacturers may use different setup codes for the same product category. For that reason, it is important
that you check to see if the code you have entered operates as many controls as possible. If only a few
functions operate, check to see if another code will work with more buttons.
• When operating a Sherwood CD player or tape deck using the system remote control, aim the remote control
at the REMOTE SENSOR on this receiver.
However, in case of Sherwood DVD player and MD recorder, aim it at the REMOTE SENSOR on the
corresponding component.
ENGLISH