Filter
Top Products
ENGLISH
36
Adjusting the current channel level
Press the CHANNEL LEVEL button.
1
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
( ): Possible depending on whether the surround back channel is set to "2
CH" or "1 CH".
< >: Possible only when the digital signals from Dolby Digital or DTS
program sources that include LFE signal are input.
• Depending on the speaker settings("NONE" or "NO" , etc.) and surround mode, etc., some channels
cannot be selected.
• When the SPEAKER button is set to off, only the Front Left and Front Right channels can be selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the
program sources or to suit your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into
user’s memory ("CALIBRATE"), not into preset memory("REFERENCE 1", "REFERENCE 2").
Select the desired channel.
2
• The LFE level can be adjusted within the range of
-10~0 dB and other channel levels within the
range of -15~+15 dB.
• In general, we recommend the LFE level to be
adjusted to 0 dB.(However, the recommended
LFE level for some early DTS software is -10 dB.)
If the recommended levels seem too high, lower
the setting as necessary.
Repeat the above steps and to adjust each channel level.
4
• Then the memory mode ("CALIBRATE" or
"REFERENCE 1") is displayed for several
seconds.
• When the memory mode or channel level
disappears, press this button again.
Adjust the level of the selected channel as desired.
3
DTS LFE or Dolby Digital LFE