Filter
Top Products
24
ENGLISH
Programming a macro function
Example: When playing a DVD on the DVD player
connected to VIDEO 2 jacks of this
receiver.
1. Press “AUDIO” button to control this receiver.
2. Press “POWER ON” button to turn this
receiver on.
3. Press “VIDEO 2(7)” button to select the
desired input source.
4. Press “DVD” button to control the DVD player.
5. Press “POWER ON” button to turn the DVD
player on.
6. Press “PLAY ( )” button to start playback.
• Each time the operation buttons are pressed,
the programmed order is displayed.
While “M1” is displayed, press the
CURSOR UP( )/DOWN( ) buttons to
select the MACRO button to be
programmed into, then press the ENTER
button.
2
Press any of the MACRO buttons
(M1~M3) to complete the programming.
4
Perform the steps and in
“Entering a setup code” procedure on
page 20 to select the macro mode
(“MACRO”).
1
• Then “OK” is displayed.
To erase a macro program
• When erasing a macro program, perform the
above steps , and , but ignore the step .
To change a macro program
• When a new macro program is stored into a
MACRO button with performing the above steps
to , the previous macro program is erased
from the memory of the MACRO button.
While “SEL” is flickering, press the
operation buttons you want to program
in order.
3
• The macro function enables you to program a
series of button operations(up to 15) on this
remote control into a single button.
• You can store up to three separate macro
command sequences into “M1”, “M2” and “M3”
buttons.
Operating a macro function
Notes:
• The codes programmed into a MACRO button will
be transmitted at an interval of 0.5 seconds.
However, some components may not be able to
complete one operation in 0.5 seconds and may
miss the next code.
In this case, the macro function cannot control the
corresponding components correctly.
• Be sure to use the remote control within the
remote control operation range of the
components.
• Depending on the operation status of the
components, etc., the macro function cannot
control the corresponding components correctly.
• Aim the remote control at the REMOTE
SENSORs of the components to be controlled
and press the MACRO button you want.
Example: When pressing “M1” button.
• Each time the CURSOR UP( )/DOWN( ) buttons
are pressed, “M1”, “M2” or “M3” is selected.
• Then “SEL” is flickering.
• If “SEL” goes off, start again from the above
step .
• Then “M1” is displayed on the LCD screen for
several seconds.
• During macro setting operation, pressing any of
the DEVICE buttons cannot exit from the macro
mode.