Filter
Top Products
98
Sounding the Metronome
The CD-2e has built-in metronome—a convenient feature for practicing an instrument.
1
Press the [ (Metronome)] button to turn the metronome on.
fig.metro-indicator-e.eps
If the metronome is on, the [ (Metronome)] button will light. At the same time, the
metronome’s indicator will start blinking on the beat.
When you press the [ (Metronome)] button once again, the metronome will turn off
(unlit).
2
Setting the sound.
fig.menu-metro01-e.eps
Press the [MENU] button to access the menu screen.
Use the [ ] [ ] buttons to choose “Sound.”
* If you press the [MENU] button while the metronome is
on, a screen where you can select the metronome sound
will immediately appear.
Press the [ENTER] button to confirm your choice.
Use the [+] [-] buttons to select the desired metronome
sound.
3
Setting the tempo.
fig.menu-metro03-e.eps
Press the [EXIT] button to return to the menu screen.
Use the [ ] [ ] buttons to choose “Tempo.”
Press the [ENTER] button to confirm your choice.
Use the [+] [-] buttons to specify the metronome
tempo.
If you press the [ ] button, the value will return to
“120.”
Value
Explanation
Click
An electronic sound will mark the beats.
Bell (factory setting) A bell will mark the beats.
Voice A human voice (English) will count the beats
Off There will be no sound; the metronome indicator will blink to mark the
beats.
Value
Explanation
=20–120 (factory setting)–250
Specifies the number of quarter-notes in one minute.
Decreasing this value will make the tempo slower. Increasing
this value will make the tempo faster.
Metronome indicator (blinking)
Red: strong beats
Green: weak beats
CD-2e_e.book 98 ページ ２００７年９月１０日 月曜日 午後８時５７分