Roland CD-2e CD Player User Manual


 
Turning the Power On and Off
(continued)
23
Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices
Convenient
Functions
Information
/ Display
Checking /
Preparations
1
On the CD-2e’s rear panel, set the [POWER] switch to the “OFF” position.
If you’re operating the CD-2e on batteries, the battery indicator will be shown on the
screen.
If you continue use the CD-2e when the batteries are low, the display will indicate
“Battery Low,” and eventually the power will turn off.
fig.icon-battery-e.eps
* The battery life given here is only an approximation. It will vary depending on the frequency and
conditions of use.
Turning the power off
Remaining battery indicator
Battery life
Continuous use
Approximately 6 hours
Sufficient capacity remaining.
Batteries are running low.
Batteries are almost empty.
Replace the batteries.
* The remaining battery indicator is only an approximation.
You must turn off the power before performing the following operations.
Switching from operation with the dedicated AC adaptor to battery operation
Switching from battery operation to operation with the dedicated AC adaptor
Note
If you want to use batteries, disconnect the dedicated AC adaptor. The batteries will not
be used as the power supply if the dedicated AC adaptor is connected.
Don’t mix new batteries with partially-used batteries, and don’t mix batteries of differing
types.
If you won’t be using the CD-2e for an extended period of time, remove the batteries to
prevent possible leaking damage.
Important
CD-2e_e.book 23 ページ 2007年9月10日 月曜日 午後8時57分